Raspberry pi mount for Two trees sapphire

PLEASE POST A MAKE IF YOU PRINT!

UPDATE: Everything is working #1! Octprint play nicely with Sapphire and I can now remotely start and monitor the printer. Really nice upgrade!

This is a mount to install a Raspberry Pi under the Two Trees Sapphire printer.

It requires no screw or no additional hardware. Just unscrew the bed module, remove 3 of the spacer, place the mount in place, re-screw everything and you're done.

There's also a spot to hook a LM2596 that will snap into place, no screw. Raspberry pi will also snap into place, no screw.

I've set the buck converter to 5.35V like the original power supply that came with it (I actually used the wire of the power block to connect raspberry to buck converter). I also ran I wire from buck to post on the PSU.

In order to connect the sapphire to the raspberry pi, you will need a usb module add-on on the board which can be found here:

https://www.aliexpress.com/item/Lerdge-X-Lerdge-K-3D-Printer-Motherboard-USB-Link-Module