Thingiverse
Raspberry Pi mounting frame
di MrFuzzy_F
7
Download
6
Likes
0
Makes
This is a mounting frame / mount for Raspberry PI models 2, 3 and 4.
The frame is meant to be attached by screws or glue to a housing or some carrier.
The Raspi mounting cones take M2.5 hex nuts from below. The frame mounting cones (the lower ones) can either take M3 hex nuts (screws coming from underside) or flat / countersunk screws coming from upper side.
The spacers can be used with shields. I am using 2.5 x 20mm screws to fix shield + spacer on the frame.
Adjust the cutout parameter in the customizer if the hex nuts fit to tightly.
The frame is meant to be attached by screws or glue to a housing or some carrier.
The Raspi mounting cones take M2.5 hex nuts from below. The frame mounting cones (the lower ones) can either take M3 hex nuts (screws coming from underside) or flat / countersunk screws coming from upper side.
The spacers can be used with shields. I am using 2.5 x 20mm screws to fix shield + spacer on the frame.
Adjust the cutout parameter in the customizer if the hex nuts fit to tightly.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
