Raspberry Pi Pico Case

A simple 2 parts snap-fit case for Raspberry Pi Pico. No screws needed. Back of case is open for wires. I use it to connect 2 ADXL345 and do the input shaper in Klipper Print settings:layer: 0.16 or lowerperimeters: 3To connect 2 ADXLs use the following pins. For the second ADXL you will need to use GPIO8, GPIO9, GPIO10 and GPIO11 according to the colors. Red and Black are the same.Klipper Configuration[mcu pico_adxl345]serial: /dev/serial/by-id/usb-Klipper_rp2040_use_your_id-xxxxx [adxl345 head]cs_pin: pico_adxl345:gpio1spi_bus: spi0aaxes_map: -z, x, -y #update your axes mapping [adxl345 bed]cs_pin: pico_adxl345:gpio9spi_bus: spi1a [resonance_tester]probe_points: 115, 115, 30 #update your positionaccel_chip_x: adxl345 headaccel_chip_y: adxl345 bed If you need a bed mount for ADXL take a look at this.Updates21.11.2022 - Add pins and Klipper configuration22.07.2022 - Version 2.1 - add a cutout for the Bootsel button. 12.07.2022 - Version 2 - add an indentation in order to make the case