MakerWorld
Electronics
Vai al Modello
Raspberry Pi Pico Mount
104
Download
24
Likes
39
Makes
I am creating a arcade and planned to use a Pico as my controller board. I was looking for a basic mount that I could screw into the bottom side of the control panel but didnt see one so designed this.Its designed around the original Pi Pico.You'll need 3mm countersunk screws to mount it to your chosen surface and M2 2mm bolts to screw it to the mount, maximum M2 of 8mm.Category: Electronics
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!