MakerWorld
3D Printer Accessories
Model downloaden
Raspberry Pi Pico Probe
6
Downloads
2
Likes
2
Makes
Tried a few of the Pi Pico cases that were out there and they didnt work for me.. So I designed one that works.The case was designed around using a Panduit Corp Ethernet patch cable.. It's 4mm in diameter.Cut one end off and solder the wires to the Pico. Wiring can be found here: https://klipper.discourse.group/t/raspberry-pi-pico-adxl345-portable-resonance-measurement/1757Then you can either cut the other end off or get a Ethernet break out PCB like the SparkFun Electronics BOB-00716 and use that to connect to the ADXL345 board the one I am using is a SparkFun SEN-09836. Note: photos were printed on an older printer before the H2D.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!