Slicer Discord
Raspberry Pi Sleeve Case Mount – 3D-printbaar model van Thingiverse Thingiverse

Raspberry Pi Sleeve Case Mount

171 Downloads
85 Likes
2 Makes
Model downloaden
This is a remix of this sleeve case for the raspberry pi. I made the 2 additions of a mounting bracket and a pi camera ribbon cable opening. These changes were made so I could easily mount my pi to my Maker Select Plus to use with Octoprint. I originally made this case for my Maker Select v2, but when I upgraded to the plus I didn't have those mounting points anymore. I think this is actually a better solution, though, since it allows for much easier cable management to the pi. The frame screws that came with the printer are a bit too small to fit the bracket so I used M3x10 screws.
Bron
Thingiverse
Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid
Eendelig Hardware nodig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 1/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
Nabewerking
Hardware
Software
Cura, PrusaSlicer of vergelijkbaar
Zelfde ontwerper, meer platforms

EG3Dprinting publiceert ook op

52 extra modellen op 1 andere platforms

Geverifieerd door overeenkomende modeltitels op platforms.
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie