Thingiverse
Raspberry Pi Stacking Mount
by crazybob1215
17
Downloads
5
Likes
0
Makes
The original version by MechJack was very slightly undersized for me and I couldn't get it properly sized even after printing a few at different scales.
This version is sized exactly for the Pi 4, but works with no issue for a Pi 3B that I have.
2020/03/21, Update 1: Added a label piece. I just write on it with a contrasting sharpie, but I could see putting tape on it first to provide a better writing surface or just emboss text on the flat side with the modeling software of your choice.
This version is sized exactly for the Pi 4, but works with no issue for a Pi 3B that I have.
2020/03/21, Update 1: Added a label piece. I just write on it with a contrasting sharpie, but I could see putting tape on it first to provide a better writing surface or just emboss text on the flat side with the modeling software of your choice.
crazybob1215 also publishes on
15 additional models across 2 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
