Thingiverse
Raspberry Pi Standoff for Ender 5 LCD
door robotologist
4
Downloads
3
Likes
0
Makes
This will allow a Raspberry Pi 3/4 to be mounted under the LCD controller screen of an Ender 5.
The holes are for M3 screws. One hole will require a 20mm M3 screw because it goes through the PI's board and the LCD's board. The other screws friction hold on the offset.
I've had success printing using Cura with tree supports.
The holes are for M3 screws. One hole will require a 20mm M3 screw because it goes through the PI's board and the LCD's board. The other screws friction hold on the offset.
I've had success printing using Cura with tree supports.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!