Raspberry Pi Y-Axis Camera Mount

This is a rehash of the raspberry pi camera bracket that attaches to the Y-axis end plate of the ender3. This is inspired by another bracket I found on Thingiverse, I found that the original did not stay in place after a little use and was just falling off regularly. I also did not like the positioning of the ribbon cable passthrough so I decided to just recreate the whole bracket from scratch.

This bracket clips on securely and the typical rpi camera case bolts right on.

To print it you'll want to make sure that it lays on its side. One side has a little arm that lets the ribbon cable slide in from the side. The closed side should be on the bed. It'll print either way but there will be extra supports to cut out if its laid on the wrong side.