Raspberry Pi Zero Battery Backup Surveillance Camera

Modified "Pi Zero Node" - 18650 powered raspberry pi zero case.

This design has a couple of tweaks. I blocked off the power USB port since the original design had a flaw (if you didn't remove power from the battery you could short the system.) I've changed this, by adding a few mm of the external wall (it affected the symmetry, but that side had a tendency to break if you put *any* pressure on it.)

Also, added a hole for mounting a raspi camera to the case, there's enough room over the leftmost side of the case to fit either the spycam version or the regular picam. Just apply some tape over the back (I didn't think there was room for a decent sliding mount inside the case.) The battery is sufficient to run for a few hours capturing timelapse/looking for movement. Otherwise, you should think of it as a backup battery.

BOM:
18650 Charging Board
[Micro USB 5V 1A 18650 TP4056 Lithium Battery Charger Module](https://www.amazon.com/gp/product/B06XQRQR3Q)
18650 Battery
[