Raspberry Pi Zero Case for Renkforce RF 100

I wanted to attach a Raspberry Pi Zero to my Renkforce RF 100 v2 Printer to run OctoPi on it. The [Make:](https://makezine.com/) case seemed like a good base, so I added the required extensions to mount it to the side of the printer.

To be able to attach the Raspberry Camera, I added a whole for the camera connector of the Pi Zero v1.3. To hide the camera ribbon cable, a lid for the fixture was added.

Additionally I added a cut out lettering to the lid, so that one is able to see the Power LED of the Pi Zero.

To mount it on the printer, I took of 4 of the M3 screws holding the acrylic sheets at the side of the printer and replaced them with M3 10mm screws.