Thingiverse
Raspberry PI Zero Case V1.1
von Nick_Kay
201
Downloads
127
Likes
2
Makes
*Note: this is for v1.1 of the pi zero and does not have a hole for the camera ribbon on later versions*
This is v.1.01 of the PIZero case. No screws needed, relies on a push fit. Gap in the lid of the case to allow access to GPIO pins, you dont even need to disconnect any wires to add or remove the PIZero from the case.
This is v.1.01 of the PIZero case. No screws needed, relies on a push fit. Gap in the lid of the case to allow access to GPIO pins, you dont even need to disconnect any wires to add or remove the PIZero from the case.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
