Raspberry Pi Zero Case with 1.8" OLED

This is another case that I am currently using as a desktop indicator. It is designed to work with the Zero W, but the connectors are brought to the edge so you could use an older zero if necessary.

M3 bolts x8mm hold the side panels in place. The panels are identical, but I have them both ways up as STL so that when they are printed a good side can be used on the outside of the case.
The pi is held in place with some 2.5mm nuts and bolts.

OLED is an atypical ST7735r 1.8" SPI module. There a few designs of these out there and this is the one with connectors at each end. I will be releasing very shortly another case to handle the other type of OLED that has the connector at one end as the mounting holes are spaced differently.

The case is designed at 50mm wide so that you can use if you want a 50mm wide piece of wood veneer, you can see this in the photo which has a piece of walnut that has been french polished. Mounting bolts for the OLED are M3 x 12mm