Raspberry Pi Zero + Ethernet/USB Hat + OLED Hat case.

I printed up a 2 part case to contain The following Raspberry Pi setup:

1x Raspberry Pi Zero W
1x Ethernet/USB Hat : https://www.amazon.com/gp/product/B07T16RSFM/ref=ppx_yo_dt_b_asin_title_o03_s00?ie=UTF8&psc=1
1x Waveshare 1.3" OLED Hat : https://www.amazon.com/gp/product/B078D6NXFM/ref=ppx_yo_dt_b_asin_title_o03_s01?ie=UTF8&psc=1

This is part of a project for Pirowflo - a Water Rower to Ant/BLE project here : https://github.com/inonoob/pirowflo Its a great open project and I wanted to give back and design a case for it the hardware that was recommended.

Putting it together:
There are 6 parts to this , the top and bottom case, and 4 standoffs. There is a taller standoff to separate the Pi from the Ethernet hat, and then a shorter standoff for the Oled Hat. Print 2x of each standoff.

The case top and the standoffs have holes for a 3mm screw to pass through, the OLED Hat and the Ethernet Hat have 3mm holes as well in the corners.

The case is base has sma