Thingiverse
Raspberry Pi Zero W Camera Case and holder
von WaldMaker
23
Downloads
11
Likes
0
Makes
I wanted to use one of my Raspi Zero W as am Octoprint Camera and eventually also as an Octoprint Server.
But I didn't find a case for the Zero W with the new V2.0 Camera.
So I designed one and would like to share it with you!
After successfully using this webcam clip on my Anycubic I3 mega X
https://www.thingiverse.com/thing:2931900
I decided to use the same arms for my smaller Anycubic I3 mega S.
To do so, you just have to cut off the upper part of the c270_support and drill a 6mm hole for the additional camera holder.
But I didn't find a case for the Zero W with the new V2.0 Camera.
So I designed one and would like to share it with you!
After successfully using this webcam clip on my Anycubic I3 mega X
https://www.thingiverse.com/thing:2931900
I decided to use the same arms for my smaller Anycubic I3 mega S.
To do so, you just have to cut off the upper part of the c270_support and drill a 6mm hole for the additional camera holder.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
