Thingiverse
Raspberry Pi Zero W Camera Pi v1
von Jonchu
28
Downloads
12
Likes
0
Makes
This is a case to hold the Raspberry Pi Zero W (guess for standard zero too).
It fits the Board perfectly, the camara has a bit of room to giggle but is fully functional.
Notice the USB OTG port has no cutout, this is on purpose. If you need this cutout too, message me and I'll update this file.
I recommend inserting the Camera Module upside down (opposite as in the picture) so the cable doesn't suffer as much. Also, by doing this the hole for the camera will let it see.
The hole for the camera is a bit too much down, i'll fix in the future.
It fits the Board perfectly, the camara has a bit of room to giggle but is fully functional.
Notice the USB OTG port has no cutout, this is on purpose. If you need this cutout too, message me and I'll update this file.
I recommend inserting the Camera Module upside down (opposite as in the picture) so the cable doesn't suffer as much. Also, by doing this the hole for the camera will let it see.
The hole for the camera is a bit too much down, i'll fix in the future.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
