Thingiverse
Raspberry Pi Zero W TARDIS Case
von Scotty-G
175
Downloads
122
Likes
1
Makes
Inspired by Jason3030's Raspberry Pi 3 TARDIS Case (https://www.thingiverse.com/thing:2430122), I decided to try and make one for a Raspberry Pi Zero W. Scaled down to 80% before determining placement of Pi Zero card and cutting out access holes.
Printed at .1mm layer height - not the cleanest print but good enough for now.
0.2" (~5mm) standoffs were used, along with 2-56 thread countersink screws.
Didn't have any 2-56 nuts available so used spare standoffs in their place.
Printed at .1mm layer height - not the cleanest print but good enough for now.
0.2" (~5mm) standoffs were used, along with 2-56 thread countersink screws.
Didn't have any 2-56 nuts available so used spare standoffs in their place.
Scotty-G veröffentlicht auch auf
38 zusätzliche Modelle auf 2 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
