Thingiverse
RaspberryPi A+ Case with magnets
door qubit01
26
Downloads
22
Likes
0
Makes
A case for the RaspberryPi Model A+.
The RPi is held in with 2.5mm screws in the bottom shell. The screws are directly bolted into the plastic. I usually make sure that the holes fit the thread by drilling it with a 2.2 mm drill.
The top attaches to the bottom by 4 magnets. With that I am able to achieve that there is not a single screw, fastener, etc. on the outside of the case.
The RPi is held in with 2.5mm screws in the bottom shell. The screws are directly bolted into the plastic. I usually make sure that the holes fit the thread by drilling it with a 2.2 mm drill.
The top attaches to the bottom by 4 magnets. With that I am able to achieve that there is not a single screw, fastener, etc. on the outside of the case.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
