ratchet strap holder

after designing my ratchet strap winder i needed a way to hold the staps and keep them from unwiding.now an elastic band would of been easier but wheres the fun in that. these hold 4.5mx25mm ratchet straps the internal measurements of the holder is 52mm wide x 26mm deep x 92mm tall (keep in mind the strap will squeeze in a certain amount so aslong as there close then they should fit)the hook holder width is about 6.1mm it will open up a bit but not loads so dont try to force in one thats to big as youll most likely just break it please consider rating if you print check out my other models including my ratchet strap winder (1813881)