RatRig V-Core 3 Corner Brackeds

I designed these corner brackeds to make processing the plexi panels easier. Nice side effect: The corner brackeds also look good.
The Bracked_Ventholes are symmetrical and designed for the RR-Vcore 3 400x400.

Update: i included the dxf files for the Sidepanels and Backpanel. These are also designed for the RR-Vcore 3 400x400.
i also uploaded the Chamber Separator witch seperates the Printroom from the elektroniks space. these are also symmetrical.
I also added a textured alternative

Update2: i included the Front Door with Hinges. You'll need 5 Door Hinges and the Hinge Oben and Hinge Unten. The Hinge is designed to place on the left or right side of the Printer. For the hinge you'll need an 5mm rod with 410mm lenght
To close the door i am going to use this: https://www.thingiverse.com/thing:2537046

Attention: the hinges are designed for 3mm acryl. I don't know if these are stable enogh. i should get my 3mm acryl side panels at 09.08.2021. At this point i can try if the 3m