Razer Core X tiny travel case

This is a custom tiny travel case for the Razer Core X.

This case was designed to fit a dual slot width GFX card, there is +/- 2mm-3mm of clearance left so a slightly thicker card might still fit this design.

The clearance between the lid and the PC board components might have to be adjusted for your individual circuit board as some of the components have a tight fit and manufacturing variances may cause some of the parts to interfere with the front end of the lid. Sharp side cutters can be used to snip away a print layer or two if the clearance isn't as desired.

The unthreaded holes were also designed to be smaller than the screw diameter of the screws used in the Razer Core X to ensure a tight fit. These are effectively large pilot holes so a little widening or tapping may be required depending on the screws used, I would advise to test each screw connection point prior to attaching the circuit board.

The power supply is still required for the circuit board to function