Thingiverse
Razor Stand
by danielzn
1
Downloads
2
Likes
0
Makes
This stand can hold a razor that has a minimum diameter of 12mm. You can probably scale the entire design up to increase this number.
Print the base and head piece on their flat sides. Print the cylinder piece horizontal with supports at greater than 35 degrees. You may need to sand down the edges of the two circle faces of the cylinder.
No other printer requirements.
Print the base and head piece on their flat sides. Print the cylinder piece horizontal with supports at greater than 35 degrees. You may need to sand down the edges of the two circle faces of the cylinder.
No other printer requirements.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!