Thingiverse
Razor Wall Hanger
door northstarVimes
3
Downloads
2
Likes
0
Makes
Needed a razor holder/wall hanger, and wanted to learn how to do 3d modeling for printing, so I made this to hold my Harry's brand shaving razor in the shower, with small drainage holes on either side.
Fits a small Command strip refill almost perfectly (you can see it peek out a tiny bit in a photo, could always trim it if you find it bothersome), or double-sided tape would work to hold it in the shower or against whatever flat surface you prefer (inside the medicine cabinet, perhaps).
My first design, so hello world! Hope you find it useful.
Fits a small Command strip refill almost perfectly (you can see it peek out a tiny bit in a photo, could always trim it if you find it bothersome), or double-sided tape would work to hold it in the shower or against whatever flat surface you prefer (inside the medicine cabinet, perhaps).
My first design, so hello world! Hope you find it useful.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!