Thingiverse
RB3 Flat LCD Face Plates.
von JP1
6
Downloads
5
Likes
1
Makes
This is a flat faced LCD mounting system for RB1's, and RB3's. The system will adapt to Regular and Big versions of both printers. It is also designed to allow the original RB1 LCD to be adapted with the new buttons and cables and allow RB2 components to be completely transferred into the RB3 frame. The LCD will fit very snugly in between the front rails of the printer. The LCD PCB board must be tilted back and up to go behind the Y rod mount. It does fit.
The part files include the LCD mounting panel, the RB3 Logo panel, the center expansion panel for the Big version, and bracket braces. The parts are designed to be printed on an RB2 or RB1 10 x 10 bed.
One bracket brace is needed for the Regular size and two are used for the Big version. They are placed on the bottom rail where the connection seams are for the panels.
The panels are joined using M3 (8mm long) bolts that are common to the printer kit. Pre-threading the bolts into the small holes will greatly simplify
The part files include the LCD mounting panel, the RB3 Logo panel, the center expansion panel for the Big version, and bracket braces. The parts are designed to be printed on an RB2 or RB1 10 x 10 bed.
One bracket brace is needed for the Regular size and two are used for the Big version. They are placed on the bottom rail where the connection seams are for the panels.
The panels are joined using M3 (8mm long) bolts that are common to the printer kit. Pre-threading the bolts into the small holes will greatly simplify
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
