Slicer Discord
RC Boat model Adaptions – Modelo 3D imprimible de MakerWorld MakerWorld
RC

RC Boat model Adaptions

por schmieeed · RC
39 Descargas
31 Likes
1 Makes
Ver Modelo
I printed everything from the original post and tried to build the boat. In general it works well only some parts like the Rudder and the engine makes me some trouble. So I ordered several other parts instead of the listed ones.Following a list of adaptions and also additional/modified parts. 1. RudderI ordered the Krick Rudergarnitur groß 36x50 mm (Artikel-Nr.: ro1481)The shaft needs to be cutted off and the hole enhanced. A seal is included. 2. Motor / EngineI tried the 130 Motor, listed in the post but it blown up after 5 Minutes :-(The 540 Motor worked longer but the rotation speed is in my opinion way to high and the printed gears are very loud and i don't trust them at all!My solution is also from Krick, I bought the Max Power 400 Electric Motor (Artikel-Nr.: 42116) and the this universal Electric Motors interference set (Artikel-Nr.: 42128)The technical data fits very well and no further transmission is needed:Shaft diameter 2,3 mmRated voltage 7.2 V @ 7500 rpmOperating volt
Categoría
RC
Fuente
MakerWorld
Publicado
Actualizado
Lo que necesitas para imprimir: Principiante Baja confianza
Pieza única
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 0/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
Cama mín.
50 mm (Pequeño)
Software
Cura, PrusaSlicer o similar
Mismo diseñador, más plataformas

schmieeed también publica en

15 modelos adicionales en 1 plataformas más

Verificado por coincidencia de títulos de modelos entre plataformas.
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección