Thingiverse
RC Boat servo holder
von Mothra78
244
Downloads
189
Likes
0
Makes
The rudder servo on my RC Boat used to be glued with double sided tape and came off once.
So I designed a servo holder in Sketchup, printed it and glued it once the servo was in it in the boat with Epoxy.
Tested it this morning it works fine and allows sharp turns.
So I designed a servo holder in Sketchup, printed it and glued it once the servo was in it in the boat with Epoxy.
Tested it this morning it works fine and allows sharp turns.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
