Thingiverse
RC Car Flat Pushpin or Flat Cone
por FernandoF
3
Descargas
1
Likes
0
Makes
Used to define and limit the round trip lanes in a off-road R/C Car circuit.
Very easy to print, just do it as is and add a bit of support on the center of the dish and the spike to hold the top roof of the flaps. Note that once printed, that flaps acts as a spring so they can be bended a bit to fit them in place. See pictures for better understanding.
Place them wherever you want and push down to stick them on the ground, be sure ground is not too hard!
100% infill for the dish
20% infill for the spike
Enjoy!
Very easy to print, just do it as is and add a bit of support on the center of the dish and the spike to hold the top roof of the flaps. Note that once printed, that flaps acts as a spring so they can be bended a bit to fit them in place. See pictures for better understanding.
Place them wherever you want and push down to stick them on the ground, be sure ground is not too hard!
100% infill for the dish
20% infill for the spike
Enjoy!
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!