Thingiverse
RC Drift Tap Ball
door Oopie54
0
Downloads
5
Likes
0
Makes
A drift tap ball thing that you try to hit with your quarter panel of rc car.
print one of each part except only use either 4 split links or 2 female split links and 2 male split links. the upright goes in the square hole in the base as shown in the pictures, and the split links go together and connect the chain to the upright and then connect to the ball. Printed fully in PLA
https://www.youtube.com/watch?v=Lx294D57YQQ&t=2s
*inspired by APEX RC Garage on youtube
print one of each part except only use either 4 split links or 2 female split links and 2 male split links. the upright goes in the square hole in the base as shown in the pictures, and the split links go together and connect the chain to the upright and then connect to the ball. Printed fully in PLA
https://www.youtube.com/watch?v=Lx294D57YQQ&t=2s
*inspired by APEX RC Garage on youtube
Oopie54 publiceert ook op
6 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
