RC drop 270mm

This RC candy drop is intended to be used with Tower Pro MG 90 servos and the chamber is designed accordingly. If you can size servos close to these that should make installation easier. If you prefer a shorter version there is a 230mm version here (https://www.thingiverse.com/thing:3370694). The flat clips are to hold down the servos in the tray. The small hinges can be assembled by sliding some PLA into the holes for a rod pin, then just glue the hinges in place when lining the doors up with the main chamber. Just use standard push rod pieces to construct the mechanism from the control horn of the servo to the flap on the door.

For full size printing, this was designed to be printed on a 300mm x 300mm printer, but you can simply scale it to fit yours. However note that scaling will cause the servo chamber area to change and could result in needing to redo that to fit your chosen servo.

This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/k5XMj