RC EDF Outrigger

Warning
There is a high risk of total loss of the boat/craft.

Test run:
https://www.youtube.com/watch?v=chB-g0aLZ-g

There is a high risk of water getting inside the hull. Seal/plug unused holes and seal lids carefully. Seal around cables.
Angle the rudder leading edge so that the bottom corner is the most forward one. See image.
Rudder dimension: Length about 42mm, height about 33mm (about 29mm in water).

Servo/Rudder holder is just for testing. Will probably change shape.
First test:
https://www.youtube.com/watch?v=IjCiJjNobmI

New front part "Front_v3". Found an error in the old one.

Rear_v2:
Changed the opening for "one size lid" (Lid_v2). Added a groove in the stern to test a fibre/thread reinforcement (reinforcement from the carbon tubes around the stern).

Lid_v2:
One size lid (for "Rear_v2").

Added "138.5mm.stl" to help glue the sponsons in place on 400mm tubes (6mm tubes).
Added an "extension" if you want to try another hull length (I have not used