Thingiverse
RC ESC Wire holder/Clips
von Pique_lec
91
Downloads
88
Likes
0
Makes
ESC wire clips or a holder to keep your wiring neat and tidy.
Use 3M adhesive tape or drill a hole for screw in it base to secure it to a surface.
ver1 & ver2 files are for 12-14 AWG wire size.
ver3 & ver4 files are for 8-10 AWG wire size.
Recommend to print is on its side and not in standing position.
Use 3M adhesive tape or drill a hole for screw in it base to secure it to a surface.
ver1 & ver2 files are for 12-14 AWG wire size.
ver3 & ver4 files are for 8-10 AWG wire size.
Recommend to print is on its side and not in standing position.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
