Thingiverse
RC F35C
von m0nke7
51
Downloads
174
Likes
1
Makes
This is updated version of my old F35C. Old version had only 2 control surfaces,
Whereas new version has all 6 like the real one.
Updated version also decreased in size and weight.
Scaling down did not have any impact on performance of the engine as the air intakes are still big enough.
However, LW-PLA and AERO-PLA are still recommended.
Make sure that your battery fits, if it doesnt: edit middle and nose parts.
Make sure that CG is where it supposed to be, CG mark is on the bottom.
You might need to increase infill percentage in some parts in order to make them stronger.
Also you might need to change infill percentage to get to make plane balanced.
Whereas new version has all 6 like the real one.
Updated version also decreased in size and weight.
Scaling down did not have any impact on performance of the engine as the air intakes are still big enough.
However, LW-PLA and AERO-PLA are still recommended.
Make sure that your battery fits, if it doesnt: edit middle and nose parts.
Make sure that CG is where it supposed to be, CG mark is on the bottom.
You might need to increase infill percentage in some parts in order to make them stronger.
Also you might need to change infill percentage to get to make plane balanced.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
