Thingiverse
RC glider piggyback
von TjomBucket
1
Downloads
4
Likes
0
Makes
This is a glider piggyback release that I made to piggyback shuttle gliders and other planes on top of my flying wing.
This piece is designed to fit into my quick release system that can be found with my other projects on my profile.
if you want to build your own base/ quick release, the size of the base is 3.9" wide 4" long and .2" thick.
To finish this build:
1. a 9 gram servo (any will work but it was designed for a 9 gram)
2. wire from a coat hanger (or any wire between.09" and .1")
This piece is designed to fit into my quick release system that can be found with my other projects on my profile.
if you want to build your own base/ quick release, the size of the base is 3.9" wide 4" long and .2" thick.
To finish this build:
1. a 9 gram servo (any will work but it was designed for a 9 gram)
2. wire from a coat hanger (or any wire between.09" and .1")
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
