Thingiverse
rc model cover latch
door WRudy
6
Downloads
3
Likes
0
Makes
just a hatch latch done for atomRC Dolphin but can be used anywhere, mount it close to the stock cover handle to click in
Additionally, you'll need:
2.5-3mm diam. 10-15 mm long screws (one per latch)
~10x15mm 2-3mm thick plywood glued into the foam with UHU Por
how to use it:
1) cut the slot in the foam ~8-10mm below the hole in the latch and glue the piece of plywood into the slot
2) try fit the latch with the cover on to click into the cover handle
3) mark the place where screw will go, drill the hole through the plywood
4) screw the latch to be barely loosy
Additionally, you'll need:
2.5-3mm diam. 10-15 mm long screws (one per latch)
~10x15mm 2-3mm thick plywood glued into the foam with UHU Por
how to use it:
1) cut the slot in the foam ~8-10mm below the hole in the latch and glue the piece of plywood into the slot
2) try fit the latch with the cover on to click into the cover handle
3) mark the place where screw will go, drill the hole through the plywood
4) screw the latch to be barely loosy
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!