Thingiverse
RC MTLB apc
door TheFanGuy
0
Downloads
2
Likes
0
Makes
THIS IS NOT THE FINAL VERSION FEEL FREE TO REMIX IT
I used old RC car electronics to power it and rubber bands for suspension. The holes for sprockets should be drilled, these ones just match old the parts i had. You might have trouble orienting the front bottom part, but everything should fit on a 220x220 bed. Print the front roof on its walls.
Use supports and all parts should be fine on 20% infill, you might want to reinforce the hull walls.
the model is mostly accurate, about 22:1 scale (not sure, its been some time since i designed it), most of the tracks is guesswork, so dont expect to much detail from the model ;)
I used old RC car electronics to power it and rubber bands for suspension. The holes for sprockets should be drilled, these ones just match old the parts i had. You might have trouble orienting the front bottom part, but everything should fit on a 220x220 bed. Print the front roof on its walls.
Use supports and all parts should be fine on 20% infill, you might want to reinforce the hull walls.
the model is mostly accurate, about 22:1 scale (not sure, its been some time since i designed it), most of the tracks is guesswork, so dont expect to much detail from the model ;)
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
