RC plane stand

I picked up the design of 'poharatek' and edited it to my needs. Many thanks for publishing!

I reduced the number of items to print by combining the tube-holder with the feet - making one part out of these 3.
The fit of the up/down slider was too tight on my prints so I modified the fit and made the parts a little thinner as well - saving 20% material and time (my printer is not fast ;-) )
The only part where I used supports was the 'Pipe_Connector' as this was printed sideways.
The knobs were printed without supports and loose print-strings in the hole were removed before fitting the nut.
(This was easier than removing a support from this hole)
You need 4 big knobs and 6 small ones.

additional parts:
2x M6 carriage bolt 40mm long
8x M6 carriage bolt 30mm long
10x M6 nut
2x 32mm (1 1/4 inch) outer diameter PVC tube 50cm long
foam rubber pads