Thingiverse
RC Power Distributor
von alekimura
1
Downloads
0
Likes
0
Makes
The Female Bullet terminals were glued with epoxy, the switches are graded for 6A@125V, but I don't trust it, so i'm just using for the Pit Led or something under 50W.
I forgot to fit a 12V to USB stepdown board inside, but i'll be making a v2.
The screws on the voltimeter are m2 and on the bottom cover m3.
I forgot to fit a 12V to USB stepdown board inside, but i'll be making a v2.
The screws on the voltimeter are m2 and on the bottom cover m3.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!