Thingiverse
RC Servo Wire Holder
by Bob99
34
Downloads
23
Likes
0
Makes
UPDATE March 3, 2021: ADDED much smaller version. See "Servo Wire Holder Small Version.STL" The larger version (of which there are 8 files) is not suitable for small spaces so this version is meant to fit in tighter spaces. If you don't need 8 slots you can snip off the number you need. Dimensions are: 31mm long, 8mm tall, 6mm wide. Good for JR and Futaba servo wires.
ORIGINAL March 2, 2021: These are servo wire holders that can be fastened (glued, etc.) to the fuselage of your RC aircraft or other vehicle in order to keep long wire runs straight and organized.
Wires are pressed into the slots with moderate pressure. The openings have slight 'nubs' to keep the wires within the slot.
The slots are sized for JR and Futaba servo wires.
You can print them as you find in the STL's or rotate them 90 degrees on the X-axis, either way works well. No supports needed.
ORIGINAL March 2, 2021: These are servo wire holders that can be fastened (glued, etc.) to the fuselage of your RC aircraft or other vehicle in order to keep long wire runs straight and organized.
Wires are pressed into the slots with moderate pressure. The openings have slight 'nubs' to keep the wires within the slot.
The slots are sized for JR and Futaba servo wires.
You can print them as you find in the STL's or rotate them 90 degrees on the X-axis, either way works well. No supports needed.
Bob99 also publishes on
9 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
