RC Setup Board Leveling Tool

# RC Setup Board Leveling Tool
## History
I recently attended a 2WD-Buggy Off-Road-Race. While doing setup on my car I thought leveling the board with a cooler tool than a clearance-gauge would be nice.

## Purpose
Leveling your setup board.

## Printing
I used PLA+ and no support.

## Addionally needed parts
* 8 x M3 nuts
* 4 x M3 8mm set-screws[1]
* 4 x M3 16mm or 20mm set-screws[1]

## Assembly
* Print the parts according to your board thickness (adjust if necessary, it's OpenSCAD, so Customizer should work)
* Fetch above mentioned hardware
* Insert the nuts into the slots (I used a vise to press 'em in)
* Insert the set-screws
* Attach the B-Part (foot)

## Usage
* Mount them on your board, careful while fastening so the board doesn't get damaged
* Use a circular spirit level to monitor your adjustment results
* Adjust level

## Footnotes
[1] ordinary screws will also do, but have two disadvantages: 1. Will be in the way; 2. Range limited since head mu