RC Trommel

Hello,

I modeled and printed this to use with my rc construction equipment. I used bearings and silicon grease for the trommel portion. It is ran off of a 12v geared motor I purchased on amazon. My printer is not that big so I cut up most pieces to fit and then glued them together. The main parts were screwed together using m3 hardware. At this point, I wont be using any supports or rollers for end of trommel. It actually spins pretty decent and can support the weight of dirt and rocks going through it. At least for now anyways lol
I will try and update with a parts list as soon as I can.

Parts List:

m3 x 12mm
m3 lock nuts
m3x 8mm
m3 grub screws (set screws)
m2 x 10mm (for drum)
m2 nuts (for drum)
37mm Geared motor
Cheap arduino motor controller or you can run directly off battery. I chose motor controller to test different rpm geared motors
3- 10x5x3 Bearing
3- 13x6x5 Bearing
1- 14x5x5 Bearing

**UPDATE 02/19/23 I have added some updated files and pictures