RC2014 Backplane 8 Case

These are the files needed to create a case for the RC2014 Backplane 8. This smartens up your retro homebrew Z80 computer nicely!

This is designed to be cut from Perspex, although would probably look good in other materials. Layer 3 needs to be 5mm thick to clear the components and layer 4 should be 3mm or less. The bottom 2 layers are less important.

If layer 3 is clear Perspex then you will get a nice glow all around your RC2014 from the power LED :-)

The cutouts have been included for all the options on the board, however, if you do not have everything installed, you can remove the holes from the top layer for a cleaner finish.

Unless you already have an RC2014, this probably isn't something you would need. However, if you don't have a RC2014, get yourself over to Tindie.com to check it out ;-)