Thingiverse
RCA cable clip
door Gertsen
4
Downloads
3
Likes
0
Makes
A friend needed a simple way to keep a cable in place, so we designed this clip to snap into two RCA connectors.
Though the model is upright, I recommend printing it on the side like shown in the picture.
We printed 8 of theese, and they worked directly out of the printer, no post-print cleanup required.
When we printed it standing up, like in the model, the quality was MUCH lower, and strength was very poor. Also it would have required ALOT of cleaning up with a knife or sanding it, not worth it when printing it on the side solves all problems.
Though the model is upright, I recommend printing it on the side like shown in the picture.
We printed 8 of theese, and they worked directly out of the printer, no post-print cleanup required.
When we printed it standing up, like in the model, the quality was MUCH lower, and strength was very poor. Also it would have required ALOT of cleaning up with a knife or sanding it, not worth it when printing it on the side solves all problems.
Gertsen publiceert ook op
25 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
