Thingiverse
RCBS Primer Catcher Catcher
by IVIUPPET
175
Downloads
88
Likes
1
Makes
TL;DR: for when you don't have a suitable/design-intended hose on hand to send your spent primers into the garbage. it uses a 'negligible' amount of filament instead. I have not yet purchased a hose.
----------------
I love the new primer catcher my RCBS Rock Chucker sports:
http://www.thingiverse.com/thing:1223108
Might also work with this primer catcher:
http://www.thingiverse.com/thing:148190
Or its predecessor:
http://www.thingiverse.com/thing:84047
While it works well (much better than stock piece of sh!t), the spent primers are dumped onto the floor unless connected to a trash can with a 1/2" vinyl hose. I just taped a bag onto the spout, but it fell off after a bit.
Anyway, I don't have a hose, but I do have a 3D printer, so I made this Thing to catch the primers from the primer catcher, hence primer catcher catcher. There is also an optional countersunk #8 screw hole to keep it in place. Inside edges are blended to make removal of spent primers with fing
----------------
I love the new primer catcher my RCBS Rock Chucker sports:
http://www.thingiverse.com/thing:1223108
Might also work with this primer catcher:
http://www.thingiverse.com/thing:148190
Or its predecessor:
http://www.thingiverse.com/thing:84047
While it works well (much better than stock piece of sh!t), the spent primers are dumped onto the floor unless connected to a trash can with a 1/2" vinyl hose. I just taped a bag onto the spout, but it fell off after a bit.
Anyway, I don't have a hose, but I do have a 3D printer, so I made this Thing to catch the primers from the primer catcher, hence primer catcher catcher. There is also an optional countersunk #8 screw hole to keep it in place. Inside edges are blended to make removal of spent primers with fing
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!