RCExplorer Bicopter
door rsheldiii
29
Downloads
23
Likes
1
Makes
https://www.RCexplorer.se is closing but David was nice enough to open source his designs. They're F3D files so I'll be parting out the bicopter stuff for easier 3d printing. I've placed them under the same license; BiCopter.zip is the original file and contains the license readme. the downloads page for these models are here: https://rcexplorer.se/downloads/
This is the parts for the bicopter, minus the tilt mechanisms - which you can find [here](https://www.thingiverse.com/thing:4086482).
I give no guarantees as to the viability of 3d printing these components, especially since these were pretty experimental craft, and I'm not experienced enough to diagnose any issues that arise. I'm assuming the PIDs will need to be tuned at the very least.
# BOM:
1. 2x [tilt mechanisms](https://www.thingiverse.com/thing:4086482).
2. 4x Plate
3. 2x Side
4. 1x of everything else listed here
5. all the mounting hardware and electronics and such (check out the [website](https://rcexplo
This is the parts for the bicopter, minus the tilt mechanisms - which you can find [here](https://www.thingiverse.com/thing:4086482).
I give no guarantees as to the viability of 3d printing these components, especially since these were pretty experimental craft, and I'm not experienced enough to diagnose any issues that arise. I'm assuming the PIDs will need to be tuned at the very least.
# BOM:
1. 2x [tilt mechanisms](https://www.thingiverse.com/thing:4086482).
2. 4x Plate
3. 2x Side
4. 1x of everything else listed here
5. all the mounting hardware and electronics and such (check out the [website](https://rcexplo
rsheldiii publiceert ook op
4 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!