RDQ Mach 1 Canopy
von USFRobotDesignME
2
Downloads
4
Likes
0
Makes
Needed a canopy to totally enclose my RDQ Mach 1 build. Full protection and aero was the goal, so this thing came out. Thing I liked the most was the extra space above the stack. Acts as a shock-absorber during high impact, and allows good air flow.
Designed in Fusion 360.
No hardware is needed. The canopy press fits into the 30mm or 35mm standoffs.
If you don't want the fin, then just cut it off.
Print with support from bed only. 100% infill. The higher the support material fill density, the better the interior quality.
Happy flying
Designed in Fusion 360.
No hardware is needed. The canopy press fits into the 30mm or 35mm standoffs.
If you don't want the fin, then just cut it off.
Print with support from bed only. 100% infill. The higher the support material fill density, the better the interior quality.
Happy flying
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!