Thingiverse
Re-Usable Straw Holder
von AceGangHub
23
Downloads
16
Likes
0
Makes
Recently I was asked to make a better storage system for my mom's re-usable straws. She wanted a bigger box, I said why not think vertically!
The design is meant for the inside of a cabinet but can be placed anywhere! Included models are a All-In-One Unit which is a little over 300 mm long. Since this is larger than my printer's bed (and most print beds for that matter), I made a split model which uses a simple male and female pin.
If printed in the orientation the models are set in, there should be no need for supports besides the male and female pins.
*Please note: This model is designed for a wide variety of plastic straws but sizes may vary!
If you have any suggestions please leave a comment or post your make!
I post about a lot of the models I make and print on my YouTube Channel, Link here: https://youtube.com/@aceganghub
The design is meant for the inside of a cabinet but can be placed anywhere! Included models are a All-In-One Unit which is a little over 300 mm long. Since this is larger than my printer's bed (and most print beds for that matter), I made a split model which uses a simple male and female pin.
If printed in the orientation the models are set in, there should be no need for supports besides the male and female pins.
*Please note: This model is designed for a wide variety of plastic straws but sizes may vary!
If you have any suggestions please leave a comment or post your make!
I post about a lot of the models I make and print on my YouTube Channel, Link here: https://youtube.com/@aceganghub
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
