Thingiverse
Re:Zero Keychain
von JusTheo
19
Downloads
25
Likes
0
Makes
Printed using a Davinci 1.0A at Low Infill and Draft Setting on 3D Builder
I would HIGHLY suggest printing on Full Infill and putting the High Setting when printing for the best results and durability, I can't guarantee the small text in the middle will print correctly even on the highest setting.
If you make this please post a picture and put it in "I've Made it"
I would HIGHLY suggest printing on Full Infill and putting the High Setting when printing for the best results and durability, I can't guarantee the small text in the middle will print correctly even on the highest setting.
If you make this please post a picture and put it in "I've Made it"
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
