Slicer Discord
Realacc RX5808 Pro Split Receiver Case – 3D-Druckmodell von Thingiverse Thingiverse

Realacc RX5808 Pro Split Receiver Case

10 Downloads
15 Likes
0 Makes
Zum Modell
A small case for the split version of this reciever module:
http://www.banggood.com/Realacc-RX5808-Open-Source-5_8G-40CH-Split-Receiver-with-OLED-Special-for-Fatshark-Goggles-p-1068207.html

I kept it simple and small. I used ABS with 20% infill to print.
Screws: Hex m2x7,5mm from an T-Rex450kit or whatever you can find.
It fits the buzzer of 11,9/12mm diameter.
The display module is kept in place using double sided tape (on the lower stand), the diversity module can also be taped - mine hold quite good.....

There are two versions of the case for the display module:
- soldering version (see pictures)
- one for the video-cables to be connected using crimped servo-plugs

My cables always got loose when carrying my googles so I switched for the soldering version.

In the picture you can see another small casing. It's for my video-switch for VCR playback. I only had a pretty big 3-way-switch lying around. Maybe somebody also has a use for it, so I uploaded it too.


Happ
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA, ABS
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen