Thingiverse
Rear Ford Emblem Update
by Incodinc
1
Downloads
4
Likes
0
Makes
The back emblem is a bit bigger, so I just decided to make a whole other one. Kinda fitting considering the tailpipe...
Line up both models at the origin and then slice them separately. Print the blue one first and then print the silver with at least a .6mm Z-hop. Don't remove the blue. The silver is meant to bind to it.
Line up both models at the origin and then slice them separately. Print the blue one first and then print the silver with at least a .6mm Z-hop. Don't remove the blue. The silver is meant to bind to it.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!