Thingiverse
ReARM mounting bracket for RepRapGuru
von bdsnk
0
Downloads
1
Likes
0
Makes
I was in need for a mounting bracket for a Re-ARM board, and came across Speedy_67's design. Since I didn't want to drill new holes to my printer's acrilic frame, I decided to use the existing ones. So I edited the original design in FreeCAD.
My redesign added two mounting points with m3 nuts. The insert size isn't a perfect fit, so the m3 nuts can be clamped using a vise. It worked for me, and can be seen in the photos of this thing.
The dimension used was the one between the Arduino Mega holes, on the power connector side (82,55mm). In theory this mounting bracket can be used on frames made for the Arduino Mega.
BOM:
2 x m3 nuts
4 x m3 * 6mm screws
Change Log:
31/03/2022 - Files uploaded.
My redesign added two mounting points with m3 nuts. The insert size isn't a perfect fit, so the m3 nuts can be clamped using a vise. It worked for me, and can be seen in the photos of this thing.
The dimension used was the one between the Arduino Mega holes, on the power connector side (82,55mm). In theory this mounting bracket can be used on frames made for the Arduino Mega.
BOM:
2 x m3 nuts
4 x m3 * 6mm screws
Change Log:
31/03/2022 - Files uploaded.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
